All Orders Placed Before 1pm Ship Today!
All Springs In Stock
Larger ID and Wire Sizes
*Please note these are larger sized springs; 2 5/8" ID and longer lengths if needed. Our main selection and most common sizes are located on our Main Springs Page
Wire Size 243
Please visit our main springs page for 1 3/4" and 2" ID options for 243 Wire Size
Wire Size 250
Please visit our main springs page for 1 3/4" and 2" ID options for 250 Wire Size
Wire Size 262
Please visit our main springs page for 1 3/4" and 2" ID options for 262 Wire Size
Wire Size 273
Wire Size 283
Wire Size 289
Wire Size 295
Wire Size 3065
Other Options
How to measure your garage door spring(s)
How many turns to put on your springs
How to replace your springs
Spring turns chart
$14.99 Value/ FREE pair of cables with every spring order! Enter code at checkout.
7ft Door --- Enter "cables7"
8ft Door --- Enter "cables8"
*On each spring
*Best
WARNING: Torsion springs, extension springs, and other garage door hardware can cause serious injury or death if not handled and installed properly. Professional installation is recommended.
Do NOT attempt to install springs or hardware yourself unless you have the proper tools, reasonable mechanical aptitude and experience, and upper arm strength. Read and understand all instructions before you begin work.
Extension and torsion springs, along with attached hardware, are under extreme tension at all times. All tension must be released from springs before any work is performed.
How to Measure your Torsion Spring
This method of measuring your torsion spring requires you to measure the existing springs. Use this method if the door worked correctly before the spring(s) broke and the garage door has not been tampered with. To measure the torsion springs, follow each of the following steps carefully. If the garage door has two springs measure each spring individually. It is not uncommon to have two different size springs. If you prefer a matching set, we can convert a mismatched set to a matching set. You can also always call us at 260-691-3822.
Not sure what spring you need? We make it easy.
Take a picture of the garage door itself from inside your garage, and we'll tell you what spring(s) you need.
*Please note a picture of the Garage Door itself is needed, not just the springs above the door*
Email pictures to Wholesalegdparts@gmail.com
Step 1 Determine Springs ID (Inside Diameter)
For your broken spring(s) measure the inside diameter of the spring. If the spring is in one piece you can find the diameter on the cones, p175=1 3/4" and p200=2". Typically residential springs will have a 1 3/4" or 2" inside diameter.
Step 2 Determine Spring Wind
Most standard residential torsion systems have two torsion springs, one on the right and left. The Left spring is right hand wound(RHW), and the right spring is left hand wound(LHW). If one spring is broken on your torsion system, we highly recommend replacing both springs.
Step 3 Determine Wire Size
The most efficient way to measure the wire size is to measure 10 coils and then measure 20 coils and compare the measurements to the chart below. Measure to the nearest 1/16" of an inch. It is important to make sure there are no gaps between the coils. Measuring coils that have gaps will give incorrect measurements.
Step 4 Determine Spring Length
When measuring your torsion spring, remember that in order to get a proper measurement the spring must be un-wound. If the spring is in two parts, unscrew set screws and connect spring ends together to get a total measurement. Do not include the cones in the measurement.
